![]() Now glue the sides of the mansion layer and attach it to the inside of the black frame layer. Next fold the black back on the score lines. The box at the bottom should line up when you glue it on. ![]() Turn over the mansion layer and glue the purple back onto it, again paying careful attention to the orientation of the boxes. This layer will sit against the back of the shadow box. Now fold the mansion layer on its score lines, but note that you want to fold it up, not down. Be careful about where you glue it to avoid glue in places you don’t need. Study my photo below to see the proper orientation, and note that the top layer of the mansion overhangs the bottom layer by a bit. Pay attention to orientation here, because it matters if you want everything to line up when you pull up the slider. The next step is to glue the back of the mansion onto the front of the mansion. Then you glue the black gravestone-and-tree section onto the back of the purple frame, lined up with the bottom. Next, glue the gate on top of the purple frame, being careful not to put glue where none is needed. Once you have all of your pieces, begin by folding the front purple frame on the score lines. If you’re having an issue, make sure you’re using a good, clean mat and that your blade is cleaned (run it through some balled up aluminum foil to sharpen it). Note: The most difficult layer to cut is the gravestone layer simply because of its detail. This project takes six pieces of 8.5″ x 11″ paper. Other than that, everything is set for you! If you’re on a Joy, you’ll need to change the pen color to a Joy pen color. I also set the draw layer to use a pen if you’re on an Explore or Maker. If you’re cutting on a Cricut, all you need to do is upload it - I’ve already pre-set the score lines and attached them to their base layers. How to Assemble the Haunted Mansion Shadow Boxįirst, cut out your cardstock using my design (#43 in my free resource library). Use the type of cardstock you like best! Here you can see both versions: I like them both - the solid core version is a little clearer, but the white core version is a little spookier (because it looks like the branches are lit from behind). Note: I tried making the card with two different kinds of black paper - one with a solid core and one with a white core. Design #43 – My pattern files (available in my free resource library).A way to cut your pattern out (I use a Cricut).cardstock - I used solid core black, yellow, and purple, and DCWV Neutral Metallics for gray (silver) and black (graveyard layer) Easy Paper Craft Ideas & Projects Expand.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |